Description (Quantity) | Part Number |
---|---|
Screw, socket head 5/16-18x1.75 inch | 94337-91T |
Shift lever pad trim (Kit 34555-01A) | 50243-01 |
Shift lever pad trim (Kit 34551-09) | 34550-09 |
Shift lever pad | 50241-01 |
Shift lever assembly | Not Sold Separately |
1. | Put motorcycle in NEUTRAL. | |||||||||||||
2. | See Figure 1. Remove left front shift linkage screw securing front of shift linkage to shift lever. Save screw for installation. NOTE When removing footpeg mounting screws, use a 10-inch or longer extension to avoid damaging cosmetic surfaces. | |||||||||||||
3. | Remove screw securing footpeg mount. Hold shift lever and slide footpeg out through shift lever and remove. Save screw for installation and discard shift lever. | |||||||||||||
WARNING Footrests must fold up and toward rear of motorcycle if struck. Failure to set footrests to fold up and back could result in death or serious injury. (00366a) | ||||||||||||||
4. | See Figure 2. Slide left footpeg mount through opening in the shift lever and into the frame. Make sure footpeg folds upward and rearward. | |||||||||||||
5. | Apply a few drops of Loctite 271 onto threads of footpeg mounting screw. Install footpeg mount to the frame. Tighten screw to 14 N·m (10 ft-lbs). | |||||||||||||
6. | Apply a few drops of Loctite 271 to threads of linkage screw (removed earlier). Align linkage rod with shift lever and install screw. Tighten screw to 12 N·m (9 ft-lbs). | |||||||||||||
7. | Verify that the linkage is not binding or touching any other components. |
Figure 1. Remove Shift Lever
Figure 2. Install New Shift Lever |