SCREAMIN' EAGLE FORK BRACE KITS
J016232008-12-05
GENERAL
Kit Number
49192-99A, 46193-99
Models
For model fitment information, see the P&A Retail Catalog or the Parts and Accessories section of www.harley-davidson.com (English only).
WARNINGRider and passenger safety depend upon the correct installation of this kit.
If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation.
Improper installation of this kit could result in death or serious injury. (00308b)
INSTALLATION
| 1. | See Figure 1. On all models except those equipped with 39 mm diameter forks, push the dust covers off of the sliders and up the fork tubes until out of the way. On models equipped with 39 mm diameter forks, the fork brace fits over the dust cover. | |
| 2. | Align brace halves (3 and 4) tighten screws (2) finger-tight. | |
| 3. | Insert the brace between the fork tubes. Heads of screws (2) must face toward the engine. | |
| 4. | Make sure brace is down tight on fork sliders (dust covers on 39 mm diameter fork models) and install end caps (5 and 6). Lightly secure end caps with screws (1). | |
| 5. | Push down on front forks several times to seat fork brace and allow it to self-align. NOTE Tighten all screws evenly and carefully to prevent binding. | |
| 6. | Tighten end cap screws (1) and brace screws (2). | |
| 7. | Slide dust covers down onto fork brace (except on 39 mm diameter fork models) | |
| WARNING Failure to provide adequate clearance between stationary and moving parts can cause loss of control, which could result in death or serious injury. (00378a) | ||
| 8. | Check clearance between fork brace and front end components such as brake hoses and cables. Check all clearances throughout the full travel range of the front suspension. |
SERVICE PARTS
Figure 1. Service Parts: Screamin' Eagle Fork Brace Kit
Table 1. Service Parts
Item | Description (Quantity) | Part Number |
|---|---|---|
1 | Screw, socket head, 1/4-20 x 0.50 inch (4) | Not Sold Separately |
2 | Screw, socket head, 5/16-18 x 1.50 inch (2) | Not Sold Separately |
3 | Front brace half | Not Sold Separately |
4 | Rear brace half | Not Sold Separately |
5 | End cap, right | Not Sold Separately |
6 | End cap, left | Not Sold Separately |
Items mentioned in text, but not included in kit. | ||
A | Front of motorcycle | |
B | Dust cover, 41 mm diameter forks only | |
C | Slider | |