Flame Shifter Peg/Heel Rest Pad Kits
J027042007-05-15
GENERAL
Kit Number
34617-03 and 34680-03
Models
Shifter Peg Kit Part Number 34617-03 is designed for installation on all model motorcycles.
Heel Rest Pad Kit Part Number 34680-03 is designed for installation on all models equipped with Heel rest Kit Part Number 50227-01 or 50236-01.
Kit Contents
See Figure 1 for kit contents. The heel rest and shifter peg rubber treads and spacer tubes will be installed in their corresponding chrome castings.
INSTALLATION
NOTE
A Service Manual for your motorcycle is available at your Harley-Davidson Dealer. To enhance the flame pattern, orient the pegs as shown in Figure 1.
- If replacing shifter peg, remove and discard existing shifter peg. If needed, apply heat with a heat gun to shift lever threads and threads on shifter peg to aid peg removal. If installing heel rest pads, proceed to Step 3.
- See Figure 1. Using screw (6), attach shifter peg casting (1, 2) to shift lever. Tighten screw to 16.3-19 Nm (12-14 ft-lbs).
- To install heel rest pads, perform Step 2 to attach the heel rest to the right or left heel rest lever.
NOTE
Screw (6) has a lock patch to prevent loosening.
SERVICE PARTS
Figure 1. Service Parts: Flame Shifter Peg/Heel Rest Kit
Table 1. Service Parts Table
Item | Description (Quantity) | Part Number |
|---|---|---|
Heel Rest Pad Kit (Part Number 34680-03) | ||
1 | Casting shifter peg (heel rest left) | Not Sold Separately |
2 | Casting heel rest (right) | Not Sold Separately |
3 | Tread, shifter peg (heel rest left) | 34679-03 |
4 | Tread, heel rest (right) | 34682-03 |
5 | Spacer tube (2) | Not Sold Separately |
6 | Screw, hex socket, button head (2) | 94545-03 |
Shifter Peg Kit (Part Number 34617-03) | ||
1 | Casting shifter peg | Not Sold Separately |
3 | Tread, shifter peg | 34679-03 |
5 | Spacer tube | Not Sold Separately |
6 | Screw, hex socket, button head | 94545-03 |