0/0
REDUCED EFFORT CLUTCH KIT
J029602005-04-25
GENERAL
Kit Number
36808-05
Models
This kit fits all 2005 and earlier model motorcycles equipped with a Twin Cam 88® or Twin Cam 88B™ engine.
Additional Parts Required
Proper installation of this kit requires the separate purchase of a primary chaincase cover gasket and a transmission clutch release cover gasket.
WARNING
Rider and passenger safety depend upon the correct installation of this kit. Use the appropriate service manual procedures. If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation. Improper installation of this kit could result in death or serious injury. (00333b)
NOTE
This instruction sheet references Service Manual information. A Service Manual for your model motorcycle is required for this installation and is available from a Harley-Davidson Dealer.
Kit Contents
See Figure 1 and Table 1.
INSTALLATION
Replace Diaphram Spring
NOTE
Refer to the appropriate Service Manual for detailed information on the following generalized steps.
  1. Remove the primary chaincase cover.
  2. Partially disassemble the clutch pack in order to remove the diaphram spring.
  3. Assemble the clutch pack using the diaphram spring from the kit.
  4. Install the primary chaincase cover.
Replace Inner and Outer Ramps
NOTE
Refer to the appropriate Service Manual for detailed information on the following generalized steps.
  1. Remove and disassemble the transmission clutch release cover.
  2. Clean and inspect transmission clutch release cover components.
  3. Assemble and install the transmission clutch release cover, using the inner and outer ramps from the kit.
SERVICE PARTS
Figure 1. Service Parts for Reduced Effort Clutch Kit
Table 1. Service Parts
Item
Description (Quantity)
Part Number
1
Outer ramp
25605-00A
2
Inner ramp
25604-00A
3
Spring, diaphram
37882-06