0/0
CYLINDER BASE COVER
J041942006-10-09
GENERAL
Kit Number
32729-07
Models
For model fitment information, please see the P&A Retail Catalog or the Parts and Accessories section of www.harley-davidson.com (English only).
Kit Contents
See Figure 2 and Table 1.
INSTALLATION
1Remove crankcase bolt
Figure 1. Crankcase bolt location
  1. See Figure 1. Remove existing bolt from crankcase.
  2. See Figure 2. Obtain the cylinder base cover spacer (2) and 5/16-18 socket head cap screw (1) from kit.
  3. Insert the screw into the counterbored side of spacer.
  4. Loosely install the screw into the engine case. Rotate the spacer so that the 1/4-20 tapped hole is at the 6 o'clock position.
  5. Obtain the cylinder base cover (3) from kit.
  6. Temporarily position the cover and align the cylinder base cover hole with the spacer hole. If necessary, rotate the spacer slightly to achieve the best cover fit along the primary.
  7. Remove the cover and grasp the sides of the spacer with an open end wrench to maintain its position. Tighten screw to 15-19 ft-lbs (20.3-25.8 Nm).
  8. Place washer (4) on socket head bolt (5) from kit. Slide bolt and washer through cylinder base cover (3) and install bolt in spacer. Tighten bolt to 80-100 in-lbs (9.0-11.3 Nm).
SERVICE PARTS
Figure 2. Service Parts: Sportster Cylinder Base Cover
Table 1. Service Parts: Sportster Cylinder Base Cover
Item
Description (Quantity)
Part Number
1
Screw, socket head, 3.5 inch long
Not Sold Separately
2
Spacer, cover mount
Not Sold Separately
3
Cover, cylinder base
Not Sold Separately
4
Washer, flat, chrome
Not Sold Separately
5
Screw, socket head
Not Sold Separately
6
Emblem, Bar and Shield
14448-94