1. | Install the interface plate (5) on the studs. Install the locknuts (1) on the studs. Tighten nuts to 10.8 N·m (96 in-lbs). | |
2. | Install the guide washer (6), inner collar facing up, on the interface plate (5) stud. | |
3. | Install the new seat (4), with the slot in seat bottom engaged with the tongue on the fuel tank bracket and the rear of the seat is fastened over the interface plate stud. NOTE Adjusted to eliminate the gap between the front of the seat and the rear of the fuel tank console. | |
WARNING After installing seat, pull upward on seat to be sure it is locked in position. While riding, a loose seat can shift causing loss of control, which could result in death or serious injury. (00070b) | ||
4. | To adjust the seat, turn the seat over and loosen the two button head screws that secure the rear tab bracket (8). Slide the bracket forward or back as required. Tighten the button head screws to 10.8 N·m (96 in-lbs). | |
5. | Once adjusted, install the chrome washer (3) and acorn nut (2) onto the stud on the interface plate. Tighten to 10.8 N·m (96 in-lbs). | |
6. | Install the saddlebags. See the service manual. |
Item | Description (Qty) | Part Number |
---|---|---|
1 | Locknut (2) | 7499 |
2 | Acorn nut | 94004-90T |
3 | Chrome washer | 6277 |
4 | Seat | Not sold separately |
5 | Interface plate | 51226-02 |
6 | Guide washer | 7487 |
7 | Leather dressing (not shown) | Not sold separately |
8 | Rear tab bracket kit (includes two button head mounting screws - not shown) | 51699-09 |