BOOM! AUDIO HALF HELMET MUSIC HEADSET

J049302010-04-20

GENERAL

NOTE

Some local governments prohibit or restrict the use of headset speakers. Check with local authorities and obey all applicable laws and regulations.

Kit Number

76569-09

Models

The headset in this kit cannot be used with open face or full face helmets.

Kit Contents

See Figure 3 and Table 1.

AUDIO CABLE CONNECTION

See Figure 3. Obtain the larger clip (4) and the coiled headset audio cable (2) from the kit. Install the 3.5 mm stereo jack end of the cable into the clip.

Connect the 3.5 mm stereo jack from the headset audio cable to the audio output socket on the Road Tech riser radio, satellite radio or other audio device. Position the clip in the area indicated in Figure 1 , and rotate as needed to allow easy insertion and removal of the cable jack and audio output socket.

NOTE

Ambient temperature should be at least 16 °C (60 °F) for proper adhesion of the clip to the mounting surface.

1	For FLHT models
2	For FXD, FXST, FLST, FLHR and FLTR models

Figure 1. Clip Location

Clean the clip mounting area with a mixture of 50 to 70% isopropyl alcohol and 30 to 50% distilled water. Allow to dry thoroughly.

Peel the liner from the adhesive backing of the clip. Carefully position the clip to the mounting surface, and press firmly into place. Hold the clip in position with steady pressure for 30 seconds.

WARNING

Be sure that steering is smooth and free without interference. Interference with steering could result in loss of vehicle control and death or serious injury. (00371a)

Be sure audio connection harness or headset audio cable do not pinch, bind or interfere when handlebars are turned fully to left or right fork stops.

See Figure 3. Use the small clip (5) from the kit to retain any excess headset cable to the side of the console. Attach per Step 4.

NOTE

Allow AT LEAST 24 hours after applying the clip before exposing the area to vigorous washing, strong water spray or extreme weather.

OPERATION

1.	Plug in the coiled audio cable at the headset and audio source.
2.	See Figure 2. Put the headset on as shown, with the neck bow across the back of the head, above the neck. Put the helmet on, and fasten securely.	Figure 2. Headset Positioning
3.	Attach the clothing clip to the audio cable, and clip to clothing as desired to secure.
	NOTICE Do not pull on the cord to remove the headset from the socket. Pull on the headset jack to disconnect the headset from the socket. (00174a)
4.	Detach the audio cable from the audio source, fuel tank clip (5), clothing and headset, and store when not in use. Clip the XM satellite receiver harness output jack to the large clip (4) when not in use. Detach the audio cable from audio source and fuel tank clip before getting off the motorcycle.

WARNING

Set volume levels and other controls on audio and electronic devices before riding. Distractions can lead to loss of control, resulting in death or serious injury. (00088b)

WARNING

Do not select a volume level that blocks out traffic noise or interrupts the concentration necessary for safe operation of the motorcycle. Distractions or a volume level that blocks out traffic noise could cause loss of control resulting in death or serious injury. (00539b)

SERVICE PARTS

Figure 3. Service Parts, Half Helmet Music Headset

Table 1. Service Parts

Item	Description (Quantity)	Part Number
1	Headset assembly	Not sold separately
2	Headset cord	76571-09
3	Hardware kit (includes items 4-6)	Not sold separately
4	Clip, nylon, adhesive back 9.5 mm (⅜ in)	10325
5	Clip, nylon, adhesive back 4.8 mm (3/16 in)	10271
6	Clothing clip, stereo headset	Not sold separately