1. | See Figure 1. Remove the locknut (B) and screw (A) that hold the OE footpeg (C) in place. Save all hardware for installation of the new footpeg. | |
2. | Remove the OE footpeg (C) and spring washer (D). Save the spring washer for later installation. NOTE When installing footpeg, make sure spring washer is positioned inside footpeg support with square edge towards inside of support. | |
WARNING Footrests must fold up and toward rear of motorcycle if struck. Failure to set footrests to fold up and back could result in death or serious injury. (00366a) | ||
3. | Install the new footpeg (1) in the same manner as the OE footpeg . Place spring washer (D) and the mount end of footpeg inside the footpeg support (E) slot. | |
4. | Secure footpeg and spring washer with screw (A) and locknut (B) . Tighten locknuts to 26 N·m (19 ft-lbs). | |
5. | Rotate the footpeg to position as desired. | |
6. | Install screw (2) in the end of the footpeg, then tighten to 24–29 N·m (18–21 ft-lbs). |
Item | Description (Quantity) | Part Number |
---|---|---|
1 | Footpeg assembly (2) | Not sold separately |
2 | Screw, button head (2), 5/16-18 x 25.4 mm (1.0 in) long | 4625 |
Items mentioned in text, but not included in
kit. | ||
A | Screw | |
B | Nut | |
C | Footpeg | |
D | Spring washer | |
E | Footpeg support |