FLD WINDSHIELD KIT
J054242017-08-22
GENERAL
Kit Number
57400120
Models
For model fitment information, see the P&A Retail Catalog or the Parts and Accessories section of www.harley-davidson.com (English only).
Installation Requirements
WARNINGRider and passenger safety depend upon the correct installation of this kit.
If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation.
Improper installation of this kit could result in death or serious injury. (00308b)
NOTE
A service manual for your model motorcycle is available from a Harley-Davidson dealer.
INSTALLATION
- Lower the windshield into position by carefully inserting the side brackets until the bottom notches are seated on the lower grommets.
- From the front of the motorcycle, push the top of the windshield toward the rear until the upper notches fully engage the upper grommets.
- Push down on the wireform latch springs until the springs overhang the rubber grommets.
NOTE
Make sure that the notches on each bracket are firmly seated on a rubber grommet.
NOTE
Loosen fasteners to rotate latch springs into the proper position.
CARE AND CLEANING
NOTICE
Polycarbonate windshields/wind deflectors require proper attention and care to maintain. Failure to maintain polycarbonate properly can result in damage to the windshield/wind deflector. (00483e)
- Do not use benzene, paint thinner, gasoline or any other type of harsh cleaner on the windscreen/windshield. Doing so will damage the surface.
- Do not clean in hot sun or high temperature.
- Powdered, abrasive or alkaline cleanser will damage the windshield.
- Sunlight reflections off of the inside curvature of a windshield can, at certain times of the day, cause extreme heat build-up on motorcycle instruments. Exercise care in parking. Park facing the sun, place an opaque object over the instruments, or adjust the windshield to avoid reflections.
- Do not use benzene, paint thinner, gasoline or any other cleaning agents on the rubber bushings. Doing so will damage the bushing surfaces.
NOTE
Covering the windshield with a clean, wet cloth for about 15 minutes before washing will make dried bug removal easier.
Harley-Davidson Windshield Water Repellent Treatment (Part No. 99841-01) is approved for use on Harley-Davidson polycarbonate windshields.
SERVICE PARTS
Figure 1. Service Parts: FLD Windshield Kit
Table 1. Service Parts Table
Item | Description (Quantity) | Part Number |
|---|---|---|
1 | Windshield, clear (includes brace tape) | 57400124 |
2 | Outer LH vertical brace | 57400072 |
3 | Outer RH vertical brace | 57400073 |
4 | Outer vertical brace tape (2) | 57400085 |
5 | Outer horizontal brace | 57400071 |
6 | Horizontal brace tape (2) | 58416-77A |
7 | Inner horizontal brace | 57400070 |
8 | Acorn nuts (13) | 7651A |
9 | Plain washers (8) | 6119 |
10 | Spring latches (2) | 38722-94 |
11 | Panhead Torx screws (6) | 2452 |
12 | Panhead Torx screws (7) | 2921A |
13 | RH bracket | 57673-12 |
14 | LH bracket | 57672-12 |