See Figure 1. On right side of vehicle, locate two mounting acorn nuts (2) which secure the nacelle and the passing lamp bracket to the fork assembly.
Remove the upper and lower flat washer.
NOTE
For proper fitment, passing lamp/turn signals may have to be moved to forward portion of mounting slot.
Place the wind deflector over the nacelle mounting studs outside of passing lamp support bracket.
Adjust wind deflector as far forward as possible to allow for clearance with engine guard. Tighten nuts to 10-15 ft-lbs. Turn handlebar full left, then full right to check clearance.
Repeat procedure for installation of left wind deflector (2) on the left side of the vehicle.