SADDLEBAG LID RAIL TOURING MODEL BADGE KITS
J055742012-03-21
GENERAL
Kit Numbers
90200740, 90200741, 90200742
Models
For model fitment information, see the P&A retail catalog or the Parts and Accessories section of www.harley-davidson.com (English only).
Installation Requirements
Unless already installed, a Touring Saddlebag Lid Rail Kit (Part No. 90200737) will be needed. This item is available separately from a Harley-Davidson dealer.
Table 1. Models
Kits | Models |
|---|---|
90200740 | Limited |
90200741 | Ultra |
90200742 | FLHX |
PREPARATION
Install the Touring Saddlebag Lid Rail Kit (Part No. 90200737) per the instructions in that kit.
INSTALLATION
NOTE
The model nameplate badges are side-specific. The sides of the badges are angled to fit between the forward downtubes of the right or left lid rail.
- Position the correct badge (1 or 2) against the forward face of the lid rail downtubes.
- Position a clamp bar (3) against the rear face of the downtubes.
- Loosely fasten the clamp bar to the back side of the badge with two screws (4) from the kit.
- Repeat Steps 1-3 for the opposite lid rail.
- Visually align the badges for best appearance, then tighten the screws securely.
SERVICE PARTS
Figure 1. Component Parts, Saddlebag Lid Rail Touring Model Badge Kits
Table 2. Component Parts
Item | Description (Quantity) | Part Number |
|---|---|---|
1 | Badge (right side) | Not sold separately |
2 | Badge (left side) | Not sold separately |
3 | Clamp bar (2) | Not sold separately |
4 | Screw (4) | Not sold separately |
Items mentioned in text. | ||
A | Saddlebag lid rail (right) | |
B | Saddlebag lid rail (left) | |