1. | See the owner's manual. Remove left saddlebag. | |
2. | See Figure 1. Remove outer mount screws (1). | |
3. | Remove lower mount screws (2). | |
4. | If necessary, clean threaded holes with a thread chaser. | |
5. | See Figure 2. Place saddlebag guard over saddlebag. Align mounting holes. | |
6. | Apply a small amount of Loctite 243 - blue to screws (2). Loosely install washers and lower mount screws (2). | |
7. | Apply a small amount of Loctite 243 - blue to screws (1). Loosely install outer mount screws (1). | |
8. | Tighten screws to 10.8–13.6 N·m (96–120 in-lbs). | |
9. | See the owner's manual. Install left saddlebag. | |
10. | Repeat procedure for opposite side. |
1 | Outside mount screw (2) |
2 | Lower mount screw (3) |
1 | Outer mount screw (2) |
2 | Washer and lower mount screw (3) |
3 | Saddlebag guard rail |
Item | Description (Quantity) | Part Number |
---|---|---|
1 | Saddlebag guard, right | 90201047 |
2 | Saddlebag guard, left | 90201048 |
3 | Screw, torx, long (6) | 940 |
4 | Screw, torx, short (4) | 941 |
5 | Washer | 6703 |
6 | rubber pad (2) | 61079-82 |
7 | Bumper (2) | 62123-66A |
8 | Plug (2) | 12100067 |