AIR WING FRONT FENDER RAIL
J057792013-04-04
GENERAL
Kit Number
59600022
Models
For model fitment information, see the P&A retail catalog or the Parts and Accessories section of www.harley-davidson.com (English only).
Installation Requirements
Loctite® 271 High Strength Threadlocker and Sealant - Red (Part No. 99671-97) is required for proper installation of this kit.
INSTALLATION
| 1. | Remove the nuts that attach the fender tip to the fender. Leave fender tip installed. Do not discard. | |
| 2. | Remove the two forward facing screws that mount fork sliders to fender and discard. | |
| 3. | Install rail casting underneath fender to fender tip studs through holes (A). Attach nuts to the studs again. Do not tighten. | |
| 4. | Apply a few drops of Loctite® 271 High Strength Threadlocker and Sealant - Red on two socket head cap screws (3). Attach rails to inside of fender using socket head cap screw (3), washer (1) and flange nut (4). | |
| 5. | Remove two rear facing screws that mount fender to fork sliders and discard. Apply Loctite® 271 High Strength Threadlocker and Sealant - Red on the two socket head cap screws (3). Install the two socket head cap screws (3) and washer (1). Do not tighten. | |
| 6. | Center the fender about the tire. | |
| 7. | Tighten all four socket head cap screws (3) 19–24.4 N·m (16–20 ft-lbs). | |
| 8. | Tighten fender tip nuts to 13.6 N·m (20–25 in-lbs). |
SERVICE PARTS
Figure 1. Service Parts: Air Wing Front Fender Rail Kit
Table 1. Service Parts Table
Item | Description (Quantity) | Part Number |
|---|---|---|
1 | Plain washer, type A (4) | 6702 |
2 | fender rail | Not Sold Separately |
3 | Socket head cap screw (4) | 10200267 |
4 | Flange nut (2) | 7531 |
Items mentioned in text, but not included in kit: | ||
A | Slotted holes in front tip | |