0/0
DETACHABLE FAIRING LOWER HARDWARE KIT
J057822013-03-28
GENERAL
Kit Number
47200240
Models
For model fitment information, see the P&A Retail Catalog or the Parts and Accessories section of www.harley-davidson.com (English only).
WARNING
Rider and passenger safety depend upon the correct installation of this kit. If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation. Improper installation of this kit could result in death or serious injury. (00308b)
Additional Parts Required
Separate purchase of Anti-Seize Lubricant (Part No. 98960-97) is required for installation of this kit.
Kit Contents
See Figure 3 and Table 1.
REMOVAL
  1. Open glove box door.
  2. See Figure 1. Remove flange nut (1) securing lower fairing cap (3). Remove fairing cap.
  3. Remove retainer bolt (9) from fairing cap. Use care not to damage clip mounts.
  4. Remove lower fairing clamp screw (8), washer (7), clamp (6) and nut (5).
  5. Remove flange nuts (4) securing upper clamp (2). Remove upper clamp.
  6. Remove lower fairing assembly.
  7. Repeat all steps on other lower fairing.
1Nut, fairing cap
2Upper clamp
3Lower fairing cap
4Nuts, upper clamp (2)
5Nut, lower clamp
6Lower clamp
7Rubber washer
8Screw, lower clamp
9Retainer bolt
Figure 1. Stock Lower Fairing
INSTALLATION
1. See Figure 3. Press new clip retainer bolt (1) onto clip mount.
2. See Figure 2. Attach protective tape pads (2) to each inside half of engine guard clamps (1).
1Engine Guard Clamp
2Protective Tape Pad
Figure 2. Install Protective Tape Pads
3. See Figure 3. Insert thumb screw (4) through top side of fairing lower (A). Apply small amount of anti-seize lubricant to thumb screw (4). Thread thumb screw (4) into top half of engine guard clamp (3).
NOTE
Position fairing lower (A) on engine guard so it does not contact engine, exhaust pipes, controls or other painted parts.
4. Attach fairing lower (A) and engine guard clamp (3) to engine guard, hinge portion of engine guard clamp (3) should face toward the front of the motorcycle. Loosely thread thumb screw (4) into lower portion of engine guard clamp (3).
5. Install retainer plate (6) with thumb nuts (2). Do not tighten at this time.
6. Position fairing lower (A) to upper section of engine guard. Install fairing cap (B) over engine guard and install retainer bolts (1) through mounting holes in fairing lower (A). Install thumb nut (2) into retainer bolt (1), but do not tighten.
  1. Adjust fairing lower (A) on the engine guard to its desired position, securely tighten thumb screw (4) in engine guard clamp (3).
  2. Securely tighten three thumb nuts (2).
  3. Repeat all for other fairing lower.
SERVICE PARTS
Figure 3. Service Parts: Detachable Fairing Lower Hardware Kit
Table 1. Service Parts Table
Item
Description (Quantity)
Part Number
1
Bolt, retainer (2)
8180
2
Nut, thumb, detachable (6)
49329-07
3
Clamp, hinged, engine guard (2)
49330-07
4
Screw, thumb, detachable (2)
49333-07
5
Pad, protective tape, clamp (4) (Not shown)
59588-07
6
Plate retainer (2)
Not Sold Separately
Items mentioned in text, but not included in kit:
A
Fairing lower
B
Fairing cap