SADDLEBAG LID RAIL TOURING MODEL BADGE KITS
J058182013-05-07
GENERAL
Kit Numbers
90200951, 90200954, 90200957
Models
For model fitment information, see the P&A retail catalog or the Parts and Accessories section of www.harley-davidson.com (English only).
Installation Requirements
Unless already installed, a Touring Saddlebag Lid Rail Kit will be needed. This item is available separately from a Harley-Davidson dealer.
Table 1. Models
Kits | Models |
|---|---|
90200951 | Limited |
90200954 | Ultra |
90200957 | FLHX |
PREPARATION
If already installed, remove the Touring Saddlebag Lid Rail Kit.
INSTALLATION
NOTE
The model nameplate badges are side-specific. The sides of the badges are angled to fit between the forward downtubes of the right or left lid rail.
- Position the correct badge (1 or 2) against the forward face of the lid rail downtubes.
- Position a clamp bar (3) against the rear face of the downtubes.
- Loosely fasten the clamp bar to the back side of the badge with two screws (4) from the kit.
- Repeat Steps 1-3 for the opposite lid rail.
- Visually align the badges for best appearance, then tighten the screws securely.
- Install Touring Saddlebag Lid Rail Kit per instruction sheet in that kit.
SERVICE PARTS
Figure 1. Component Parts, Saddlebag Lid Rail Touring Model Badge Kits
Table 2. Component Parts
Item | Description (Quantity) | Part Number |
|---|---|---|
1 | Badge (right side) | Not sold separately |
2 | Badge (left side) | Not sold separately |
3 | Clamp bar (2) | Not sold separately |
4 | Screw (4) | 4628 |
Items mentioned in text. | ||
A | Saddlebag lid rail (right) | |
B | Saddlebag lid rail (left) | |