DETACHABLE PASSENGER SEAT HARDWARE KIT
J006312018-12-20
Table 1. General Information
Kits | Suggested Tools | Skill Level(1) | Time |
|---|---|---|---|
51676-97A | Safety Glasses, Phillip Screw Driver |   | 15 minutes |
(1) Only simple tools and techniques required
KIT CONTENTS
Figure 1. Kit Contents: Rider Backrest Components
Table 2. Kit Contents: Rider Backrest Components
 | Item | Qty | Description | Part No. | Notes |
|---|---|---|---|---|---|
 | 1 | 1 | H-D emblem | 14628-96 | |
| 2 | 1 | Knob, knurled, 1/4-20 | Not sold separately | |
| 3 | 1 | Flat, washer, nylon | 6441 |
NOTE
Verify all contents are present in the kit before installing or removing items from vehicle.
GENERAL
Models
For model fitment information, please see the P&A Retail Catalog or the Parts and Accessories section of www.harley-davidson.com (English only).
Ensure you are using the most current version of the instruction sheet which is available at: www.harley-davidson.com/isheets
Contact Harley-Davidson Customer Support Center at 1-800-258-2464 (U.S. only) or 1-414-343-4056.
Installation Requirements
WARNINGRider and passenger safety depend upon the correct installation of this kit.
If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation.
Improper installation of this kit could result in death or serious injury. (00308b)
INSTALL
| 1. | See Figure 2. Remove and discard screw from rear seat bracket. | |
| 2. | Slide nylon washer over threaded portion of knurled knob. | |
| 3. | Install knurled knob with nylon washer into threaded fender hole to secure rear of seat. Tighten with fingers only. | |
| 4. | See Figure 1. Remove backing paper from H-D emblem (1) and install emblem on top of knurled knob (2). | |
| 5. | Pull up on the seat to verify that it is secure. |
Figure 2. Remove Screw