NEUTRAL SWITCH COVER KIT
J020992006-04-09
GENERAL
Kit Number
33919-00
Models
This kit is designed to fit 1998-2005 Dyna® and 1998 to 2006 Touring model motorcycles.
Kit Contents
See Figure 1.
NOTE
There are no serviceable parts in this kit. Chrome buttonhead screw Harley-Davidson Part No. 94378-92T can be used as a replacement for the chrome-plated stainless steel 8-32 x .50 buttonhead screw provided in this kit.
INSTALLATION
WARNINGTo prevent accidental vehicle start-up, which could cause death or serious injury, disconnect negative (-) battery cable before proceeding. (00048a)
WARNINGDisconnect negative (-) battery cable first. If positive (+) cable should contact ground with negative (-) cable connected, the resulting sparks can cause a battery explosion, which could result in death or serious injury. (00049a)
- Disconnect the battery cables, negative cable first.
- Unplug neutral switch wires from the switch.
- See Figure 1. Loosely start the set screws (5) into the mounting bracket (2).
- Install the mounting bracket (2) over the switch hex. Bracket surface should rest against the transmission top cover with threaded holes facing up toward the rear cylinder.
- Alternately tighten the set screws (5) against the switch hex using the wrench (6) provided in kit.
- Plug in the switch wires.
- Install the cover (1) over the mounting bracket (2) using the washer (3) the 8-32 buttonhead screw (4) and the wrench (6) provided. Do not pinch wires.
- Reconnect the battery cables, positive cable first.
WARNINGConnect positive (+) battery cable first. If positive (+) cable should contact ground with negative (-) cable connected, the resulting sparks can cause a battery explosion, which could result in death or serious injury. (00068a)
| 1 | Cover, neutral switch |
| 2 | Bracket, mounting |
| 3 | Washer, chrome |
| 4 | Screw, buttonhead, 8-32 x .50 inch |
| 5 | Set screw 10-32 x .50 inch (2) |
| 6 | Wrench, 3/32 inch hex |
Figure 1. Neutral Switch Cover Assembly