0/0
LUGGAGE RACK KIT
J021582006-10-13
GENERAL
Kit Number
51119-01A, 51142-04
Models
For model fitment information, please see P&A retail Catalog or the Parts and Accessories section of www.harley-davidson.com (English only).
Additional Parts Required
Proper installation of this kit also requires prior installation of a Fender Baseplate Kit (Chrome - 51120-01A or Black - 51140-04)
Kit Contents
See Figure 2 and Table 1.
INSTALLATION
NOTE
It is not necessary to remove seat or pillion to install the Luggage Rack.
  1. If necessary, install Fender Baseplate Kit (51120-01A or 51140-04) following instructions included with kit.
  2. See Figure 1. Remove the four cosmetic screws (1) at the rear of the baseplate (2). Discard screws.
  3. See Figure 2. Obtain four button head screws (3), four spacers (2) and luggage rack (4) from kit.
  4. Orient luggage rack as shown and position over baseplate. Using four spacers and four screws, install luggage rack to baseplate. Alternately tighten screws to 28 Nm (20.7 ft-lbs).
WARNING
Do not exceed luggage rack weight capacity. Too much weight can cause loss of control, which could result in death or serious injury. (00373a)
NOTE
Maximum luggage rack weight capacity is 4.5 Kg (10 lbs).
1Screw (4)
2Baseplate
Figure 1. Remove Cosmetic Screws
SERVICE PARTS
Figure 2. Service Parts for Luggage Rack Kit
Table 1. Service Parts Table
Item
Description (Quantity)
Part Number
1
Label, load limit
Not Sold Separately
2
Spacer (chrome) (4)
33128-04
Spacer (black) (4)
33124-04
3
Screw, M8X1.25X30 (chrome)
4473M
Screw, M8X1.25X30 (black)
4285M
4
Rack, luggage
Not Sold Separately