1. | See Figure 1. Remove the OE (original equipment) reflector from the fender. Clean the adhesive from the back side of the reflector. Attach the reflector to the fender support cover (12) using new double sided tape (10) from the kit. | |||||||||||||||||||||||||||
2. | Remove the screw (1) and washer (2) securing the fender support bracket (9), fender (3) and fender support cover (12) to the fender support (13). | |||||||||||||||||||||||||||
3. | Remove the 5/16 inch bolt (4) and star washer (5) securing the rear directional light (6) to the fender. The rear directional light will remain loosely attached to the motorcycle by the rear directional wire (7). | |||||||||||||||||||||||||||
4. | Slide the sideplate (8) into place between the fender support (13) and fender (3). Line up the holes in the sideplate (8) with the holes in the fender support bracket (9). | |||||||||||||||||||||||||||
5. | Apply a few drops of Loctite 243 - Blue to the fender strut screw (1). While holding the sideplate (8) in position, install the screw (1) and washer (2). Tighten finger tight to hold the sideplate in position. | |||||||||||||||||||||||||||
6. | Apply a few drops of Loctite 243 - Blue to the rear directional light bolt (4). With the larger rear slot in the sideplate (8) lined up with the bolt hole and the smaller slot lined up with the rear directional wire (7), install the bolt (4) and star washer (5) finger tight. |
Figure 1. Right Sideplate Installation | ||||||||||||||||||||||||||
7. | Tighten the fender strut screw (1) to 16.3–24.4 N·m (12–18 ft-lbs). Tighten the rear directional light bolt (4) to 16.3–21.7 N·m (12–16 ft-lbs). | |||||||||||||||||||||||||||
8. | Repeat Steps 1-7 for the opposite side of vehicle. | |||||||||||||||||||||||||||
9. | Apply a few drops of Loctite 262 - Red to the 1/4-20 x 5/8 inch TORX® head screws (11) and install the sissy bar uprights (purchased separately). Tighten the screws to 10.8–13.5 N·m (96–120 in-lbs). |
Item | Description (Quantity) | Part Number |
---|---|---|
1 | Sideplate, right | Not sold separately |
2 | Sideplate, left | Not sold separately |
3 | Screw, 1/4-20 x 16 mm (⅝ in) long (4) | 94592-98 |
4 | Tape, double sided (2) | 53791-06 |