0/0
SISSY BAR UPRIGHT KITS
J037032006-03-24
GENERAL
Kit Number
53281-06, 53282-06, and 53407-06
Models
This kit fits 2006 and later FXST, FXSTB, FXSTS, FLSTFSE2; 2007 FXSTC, FLSTF, and FXFTSSE models with appropriate side plates.
Additional Parts Required
This kit requires the separate purchase of the appropriate sideplate kit.
Kit Contents
See Figure 1 and Table 1.
INSTALLATION
  1. Install sissy bar upright kit following the appropriate sideplate instruction sheet.
  2. If using sissy bar upright with backrest pad, install pad before applying medallion.
  3. Clean surface of sissy bar upright using a 50/50 isopropyl alcohol/water solution. Allow surface to dry thoroughly before continuing.
    4. NOTE
    Test placement of medallion on sissy bar upright before installation. Do not remove adhesive backing until ready to apply.
    The ideal temperature should be at least 60° F (16° C) for proper adhesion of the medallion on the sissy bar upright.
  4. Peel off adhesive backing on bar and shield logo medallion (1) and apply to sissy bar upright (2). Press firmly in place for 10 to 15 seconds.
  5. Allow the adhesive to cure for 12 hours at no less than 60° F (16° C).
  6. Refer to appropriate sideplate instruction sheet for torque specifications.
SERVICE PARTS
Figure 1. Service Parts: Sissy Bar Upright Kits
Table 1. Service Parts: Sissy Bar Upright Kits
Kit
Item
Description (Quantity)
Part Number
Kit 53281-06
1
Medallion, bar and shield logo
13883-00
2
Sissy bar upright, low, chrome
Not Sold Separately
Kit 53282-06
1
Medallion, bar and shield logo
13883-00
2
Sissy bar upright, medium low
Not Sold Separately
Kit 53407-06
1
Medallion, bar and shield logo
13883-00
2
Sissy bar upright, low, black
Not Sold Separately