LOWER BELT GUARD

J037062011-02-04

GENERAL

Kit Number

60317-06, 60654-07A, 60655-07A, 57100179, 57100180

Models

For model fitment information, see the P&A Retail Catalog or the Parts and Accessories section of www.harley-davidson.com (English only).

Additional Parts Required

WARNING

Rider and passenger safety depend upon the correct installation of this kit. Use the appropriate service manual procedures. If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation. Improper installation of this kit could result in death or serious injury. (00333b)

NOTE

This instruction sheet references service manual information. A service manual for your model motorcycle is required for this installation and is available from a Harley-Davidson Dealer.

Kit Contents

See Figure 3 and Table 1.

REMOVAL

See Figure 1. Remove two bolts (1) from rear inner fender (2). Lift upper right corner of fender and lift upward. Save parts for later use.

See Figure 2. Remove acorn bolt (1) from lower belt guard (2) and rear fork bracket (3). Save acorn bolt for later use.

Remove screw (4) that mounts rear fork (5) to front (slotted) portion of lower belt guard. Save screw for later use.

Hold screw (6) and washer (7) with wrench to remove acorn nut (8). Then remove screw and washer that attaches lower and upper belt guards (2, 9). Save hardware for later use.

Remove original equipment lower belt guard (2) from rear fork.

1	Bolt (2)
2	Rear inner fender

Figure 1. Rear Inner Fender

1	Acorn bolt (reuse)
2	Lower belt guard
3	Rear fork bracket
4	Screw (reuse)
5	Rear fork
6	Screw (reuse)
7	Washer (reuse)
8	Acorn nut (reuse)
9	Upper belt guard

Figure 2. Stock Lower Belt Guard

INSTALLATION

See Figure 3 and Table 1. Place lower belt guard (1) into position. Install screw (A) and washer (2) into front mounting hole of lower belt guard (1).
Install screw (B) and washer (C) through upper (D) and lower (1) belt guards, and rear fork (E). Install acorn nut (F) securely.
Install acorn bolt (G) to lower belt guard and rear fork bracket (H).
Tighten screw (A) at front of lower belt guard and rear fork to 84-108 in-lbs (9.5-12.2 Nm).
Tighten all upper and lower belt guard hardware to 60-96 in-lbs (6.8-10.8 Nm).

SERVICE PARTS

Figure 3. Service Parts: Lower Belt Guard

Table 1. Service Parts: Lower Belt Guard

Item	Description (Quantity)	Part Number
1	Lower belt guard	Not Sold Separately
2	Flat washer, 5/16 in.	6702
Items mentioned in text, but not included in kit:
A	Screw
B	Screw
C	Washer
D	Upper belt guard
E	Rear fork
F	Acorn nut
G	Acorn bolt
H	Rear fork bracket