1. | See Figure 3. Remove and discard four screws (2) and washers (3) that secure sideplate and fender support on each side of motorcycle. | |||||||
2. | Attach sissy bar (not part of this kit) to both sideplates (1) using four TORX® screws (4) from kit. Do not tighten screws. |
Figure 1. Models Without Wide Tire Kit (2000-2002) Figure 2. Models With Wide Tire Kit (2000-2002) | ||||||
3. | With sissy bar attached to sideplates, position sideplates on outside of fender supports. | |||||||
4. | Loosely install front two TORX screws (2) and washers (3) from kit through holes in sideplate, fender support, and fender. Thread into stock nut plates on underside of fender. | |||||||
5. | Raise sissy bar to access four TORX screws (4) that attach sideplates. | |||||||
6. | Remove four TORX screws (4). Apply Loctite 262 Threadlocker to threads of screws and reinstall them into sideplate holes. Tighten to 8-10 ft-lbs (11-14 Nm). | |||||||
7. | Lower sissy bar to normal position. | |||||||
8. | Install rear two TORX screws (2) and washers (3) from kit. Thread into stock nut plates on underside of fender. Tighten TORX screws to 21-27 ft-lbs (28.5-36.6 Nm). |
Kit | Item | Description (Quantity) | Part Number |
---|---|---|---|
Kit 53378-03A (Chrome) | 1 | Sideplate, right (chrome) | Not Sold Separately |
Sideplate, left (chrome) | Not Sold Separately | ||
2 | Screw, button head TORX (chrome), 3/8-16 x 1 in. (4) | 4273 | |
3 | Flat washer (chrome) (4) | 94067-90T | |
4 | Screw, button head TORX, 1/4-20 x 5/8 in. (4) | 94592-98 | |
5 | Foam tape (2006 models only, not shown) (2) | 53791-06 | |
Kit 53387-03A (Black) | 1 | Sideplate, right (black) | Not Sold Separately |
Sideplate, left (black) | Not Sold Separately | ||
2 | Screw, button head TORX (chrome), 3/8-16 x 1 in. (4) | 4273 | |
3 | Flat washer (chrome) (4) | 94067-90T | |
4 | Screw, button head TORX, 1/4-20 x 5/8 in. (4) | 94592-98 | |
5 | Foam tape (2006 models only, not shown) (2) | 53791-06 | |
Items mentioned in text, but not included in kit: | |||
A | Stock nut plate (2) | ||
B | Wire retainers (FLSTF only) | ||
C | Fender support bracket (2) | ||
Note: For 2006 and later FXST, FXSTB, and FXSTS models, relocate reflector at the center of the sideplates (Item 1). |