0/0
XL REAR AXLE COVER KIT
J038542008-04-14
GENERAL
Kit Number
46399-05, 43013-09
Models
For model fitment information, see the P&A Retail Catalog or the Parts and Accessories section of www.harley-davidson.com (English only).
Kit Contents
See Figure 1 and Table 1.
INSTALLATION
  1. Place axle covers in position over ends of swingarm with the deeper cover on the left side (covering the axle nut).
  2. Fasten the clamping bars (3) to the backs of the covers using locking hex nuts (4) and wave washers (5) securing the covers to the swingarm. Tighten the nuts evenly until the wave washers are flattened. Do not over-tighten the nuts.
    3. NOTE
    It may be necessary to change the orientation of the axle or axle nut to provide clearance for the cover.
Change the Orientation of the Axle or Axle Nut
1. Loosen the axle nut and rotate the axle to the proper orientation.
2. Tighten the axle nut to 98–106 N·m (72–78 ft-lbs). Check for clearance.
3. Repeat if necessary until the necessary clearance has been achieved.
SERVICE PARTS
Figure 1. Service Parts: XL Rear Axle Cover Kit
Table 1. Service Parts: XL Rear Axle Cover Kit
Item
Description (Quantity)
Part Number
1
Axle cover, right
Not Sold Separately
2
Axle cover, left
Not Sold Separately
3
Mounting strap (2)
Not Sold Separately
4
Nut, #10-24 locking (4)
7624
5
Wave washer (4)
Not Sold Separately