1. | See Figure 1. Install the rubber axle nut cap (1) from the kit over the axle nut. | |||||||||||||
2. | Install the rubber axle insert (2) over the axle as shown. | |||||||||||||
3. | See Figure 2. Install the rubber axle cap (1) as shown. Ensure the cap is oriented with the word "TOP" on top. |
Figure 1. Install Axle Nut Cap and Axle Insert
Figure 2. Install Rubber Axle Cap
Figure 3. Install Slider End Caps (Left Side Shown) | ||||||||||||
4. | See Figure 3. Install the outer cover (1) over the rubber axle cap as shown. | |||||||||||||
5. | Install the forward (2) and rearward (3) inner covers as shown. Ensure that they properly seat over the rubber axle insert. | |||||||||||||
6. | Apply a small amount of Loctite 243 (blue) to two screws from the kit. Secure the covers with the screws and the hex wrench included in the kit. Tighten the screws to 1.6 N·m (14 in-lbs). | |||||||||||||
7. | Repeat Steps 2 - 6 for the right side fork slider cover. |
Item | Description (Quantity) | Part Number |
---|---|---|
1 | Service kit, left side slider end cap cover | 46284-07 |
2 |
| Not Sold Separately |
3 |
| Not Sold Separately |
4 |
| Not Sold Separately |
5 |
| Not Sold Separately |
6 |
| Not Sold Separately |
7 |
| Not Sold Separately |
8 |
| 94380-92T |
9 | Service kit, right side slider end cap cover | 46623-07 |
10 |
| Not Sold Separately |
11 |
| Not Sold Separately |
12 |
| Not Sold Separately |
13 |
| Not Sold Separately |
14 |
| Not Sold Separately |
15 |
| 94380-92T |
16 | Hex wrench, 3/32 inch (not shown) | Not Sold Separately |