1. | Refer to the Owner's Manual and follow the instructions given to remove the maxi-fuse. |
Figure 1. Interface Cover Installation | ||||
2. | See Figure 1. Remove the upper front bearing housing screw (1) from the side of the transmission case. Loosen the lower front bearing housing screw (2). | |||||
3. | See Figure 2. Obtain the interface mounting bracket (2) from the kit. | |||||
4. | Hook the slot in the bracket under the head of the loosened lower screw. Install the interface mounting bracket to the bearing housing with the screw removed in Step 2, and tighten only the lower screw to 17.6–24.4 N·m (13–18 ft-lbs). | |||||
5. | Remove and discard the upper bearing housing screw installed in Step 4. | |||||
6. | Obtain the interface cover (1), two screws (3 and 5) and two flat washers (4) from the kit. Place one washer onto the threads of each screw. NOTE It may be necessary to loosen and reposition the interface mounting bracket in order to properly align the interface cover. | |||||
7. | Position the interface cover to the vehicle. Apply a few drops of Loctite 243 (Blue) to the threads of both screws. Insert the long screw through the top hole, and the short screw through the bottom hole, and loosely fasten the interface cover to the mounting bracket. | |||||
8. | Align the cover for best appearance. Tighten the screws to 17.6–24.4 N·m (13–18 ft-lbs). | |||||
9. | Refer to the Owner's Manual and follow the instructions given to install the maxi-fuse. |
Item | Description (Quantity) | Part Number |
---|---|---|
1 | Cover, interface | Not sold separately |
2 | Bracket, interface cover | Not sold separately |
3 | Cap screw, socket head, 5/16-18 x 1.75 in | 94337-91T |
4 | Washer, flat (2) | Not sold separately |
5 | Cap screw, socket head, 5/16-18 x 0.62 in | 94331-91T |