V-LOGO REAR FENDER TRIM RAIL
J047412008-03-03
GENERAL
Kit Number
91100-09
Models
For model fitment information, please see the P&A Retail Catalog or the Parts and Accessories section of www.harley-davidson.com (English only).
WARNINGRider and passenger safety depend upon the correct installation of this kit. Use the appropriate service manual procedures. If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation. Improper installation of this kit could result in death or serious injury. (00333b)
INSTALLATION
NOTE
All models for which this kit is designed are equipped with a original equipment (stock) fender rail or bumper. Remove the stock bumper and install the kit rail using following the procedures.
| 1. | See Figure 1 and Table 1. Install V-logo (4) to trim rail (1) with hex washer screws (3) and lock washers (2). | |
| 2. | Reach under rear edge of fender and remove locknut (A) and washer (B). Retain locknut and washer and use to mount new trim rail. | |
| 3. | Loosen and remove the two screws (C) and locknuts (D) which attach fender rail to saddlebag support bracket. Retain screws (C) and locknuts (D) and use to mount new trim rail. | |
| 4. | Place new trim rail in position and install washer (B), locknut (A), screws (C) and locknuts (D). | |
| 5. | Tighten locknut (A) to 5–9.6 N·m (45–85 in-lbs) and locknuts (D) to 20.3–27.1 N·m (15–20 ft-lbs). |
SERVICE PARTS
Figure 1. Service Parts: V-Logo Rear Fender Rail
Table 1. Service Parts
Item | Description (Quantity) | Part Number |
|---|---|---|
1 | Trim rail, rear fender | Not Sold Separately |
2 | Lock washer (2) | 7115 |
3 | Hex washer screw (2) | 7611 |
4 | V-logo | 91112-94 |
Items mentioned in text, but not included in kit. | ||
A | Locknut (2) | |
B | Washer (2) | |
C | Screw (2) | |
D | Locknut (2) | |