0/0
HARLEY-DAVIDSON DIGITAL TIRE PRESSURE GAUGE
J050952010-03-16
GENERAL
Kit Number
75158-10
Models
This kit adapts to all models.
Kit Contents
This kit contains one digital tire pressure gauge with battery (66373-06).
WARNING
Do not inflate tire beyond maximum pressure as specified on sidewall. Over inflated tires can blow out, which could result in death or serious injury. (00027b)
OPERATION
Setup
  1. Press and hold the button (1) until the screen flashes.
  2. Release the button.
  3. Immediately press and release the button repeatedly to locate the desired unit of measure (2).
  4. When unit of measure is located, release the button. Screen will flash briefly and the screen light will return.
Check Tire Pressure
  1. Remove valve stem cap.
  2. Apply pressure gauge chuck (5) to valve stem.
    3. NOTE
    Pressure value clears on gauge when the chuck is removed from the valve stem. Press the gauge button prior to removing the chuck (5) from the valve stem to hold the value for 2 seconds.
    Refer to the Owner's Manual for proper tire pressure.
  3. Note tire pressure on gauge.
1Button
2Unit of measure
3Battery indicator
4Anti-shock cover
5Chuck
Figure 1. Digital Tire Pressure Gauge
BATTERY REPLACEMENT
When battery indicator (3) flashes or becomes dim, replace the battery.
  1. Remove the anti-shock cover (4).
  2. Remove the body set screw with a small phillips type screwdriver and carefully separate the body.
  3. Remove the old battery and replace with a new battery (66373-06). Make sure that the positive and negative polarities are correct.
  4. Replace the anti-shock cover (4).