JIFFY STAND EXTENSION KIT
J051622010-06-07
GENERAL
Kit Number
50000008
Models
For model fitment information, see the P&A Retail Catalog or the Parts and Accessories section of www.harley-davidson.com (English only).
Additional Parts Required
Proper installation of this kit requires the use of a drill and various drill bits.
INSTALLATION
| 1. | See Figure 1. Align extension (3) on top of the jiffy stand toe bracket (A). Mark the center of the hole location. | |
 WARNINGWear safety glasses or goggles while drilling. Flying debris could result in serious eye injury. (00565b) | ||
| 2. | Drill jiffy stand extension mounting hole into the to bracket of the jiffy stand as follows: a. Use a center punch to create a drill point at the marked location. b. Use a 3 mm (⅛ in) drill bit and drill a pilot hole at the marked location. c. Use an 7 mm (9/32 in) drill bit to drill through the pilot hole and enlarge the hole. d. Remove any burrs left on the drilled hole. | |
| 3. | See Figure 1. Place extension (3) over jiffy stand toe bracket (A). Fasten extension to the toe bracket with screw (1), washers (2) and nut (4) as shown. Tighten to 8.1–10.8 N·m (6–8 ft-lbs). |
SERVICE PARTS
Figure 1. Service Parts: Jiffy Stand Extension
Table 1. Service Parts
Item | Description (Quantity) | Part Number |
|---|---|---|
1 | Screw | 94386-92T |
2 | Washer, chrome (2) | 94065-90T |
3 | Extension | Not Sold Separately |
4 | Locknut | 94026-92T |
Items mentioned in text, but not included in kit. | ||
A | Jiffy stand toe bracket | |