1. | Install rear turn signal relocation kit unless previously installed. | |
2. | See Figure 1 and Table 1. Remove the adhesive backing from the protective tape (7). Align and install the tape on the fender around the fender mounting hole. | |
3. | Install luggage rack hooks (1) into docking points (A) on turn signal stalk. NOTE If installing with a solo seat, washer (5) is used in place of seat tab (C). | |
4. | Position the seat tab spacer (6) over the protective tape and align with the mounting hole. Install with the concave side of the seat tab spacer against the fender. Place seat tab (C) over seat tab spacer. | |
5. | Position the seat tab retainer (8) under the fender. Install the luggage rack mounting bolt (2) and flat washer (3) through the rack (1), seat tab (C), seat tab spacer (6), fender, and into the seat tab retainer (8). Tighten the bolt to 16.3 N·m (12 ft-lbs). NOTE When mounting bolt (2) is removed in the future, the threads must be cleaned and Loctite 243 applied to bolt threads before being installed. Tighten to 16.3 N·m (12 ft-lbs). |
Item | Description (Quantity) | Part Number |
---|---|---|
1 | Rack, black | Not Sold Separately |
2 | Hex socket button head cap screw | 10200043 |
3 | Washer | 6101 |
4 | Label, limit | Not Sold Separately |
5 | Washer | 6397B |
6 |
| Not Sold Separately |
7 |
| Not Sold Separately |
8 |
| Not Sold Separately |
Items 6, 7 and 8 are available in a service kit (Part Number 59787-03) | ||
Items mentioned in text, but not included in kit: | ||
A | Docking point | |
B | Turn signal assembly | |
C | Seat tab |