0/0
Saddlebag Mounting Bracket Billet Trim Kit
J054652011-11-22
GENERAL
Kit Number
90200666
Models
For model fitment information, see the P&A Retail Catalog or the Parts and Accessories section of www.harley-davidson.com (English only).
Additional Parts Required
Loctite® 243 Medium Strength Threadlocker and Sealant - Blue (Part No. 99642-97) is required for proper installation of this kit.
Kit Contents
See Figure 2 and Table 1.
1Right mounting location
2Left mounting location
3Rear fender bumper
Figure 1. Saddlebag Mounting Bracket
INSTALLATION
1. See Figure 1. Remove screw from right side mounting location.
2. See Figure 2. Install billet trim to the mounting location as follows:
a. Apply a small amount of Loctite 243 - blue to a screw (4).
b. For models with a fender bumper installed: Install the right billet trim (2) over the right saddlebag bracket mounting location and secure with screw. Do not use the spacers (3) from the kit.
c. For models without a fender bumper installed: Install the right billet trim piece (2)and spacer (3)over the right saddlebag bracket mounting location and secure with screw.
d. Tighten screw to 13.5–16.2 N·m (10–12 ft-lbs)
3. Repeat procedure for left side.
SERVICE PARTS
Figure 2. Service Parts: Saddlebag Mounting Bracket Billet Trim Kit
Table 1. Service Parts
Item
Description (Quantity)
Part Number
1
Mounting bracket billet trim, saddlebag, left
Not Sold Separately
2
Mounting bracket billet trim, saddlebag, right
Not Sold Separately
3
Spacer (2)
Not Sold Separately
4
Screw (2)
3201WA