1. | See Figure 1. Remove and discard case bolt (1). | |
2. | Remove the primary fasteners shown (2). Save fasteners for installation. | |
3. | Place a small bead of silicone around the inside of the empty bolt hole from step 1. Insert the case bolt from kit through the hole in the cylinder base cover and loosely install it in the case. | |
4. | See Figure 2. Slide the inner edge of the primary cover (1) under the bottom edge of the cylinder base cover (2) and attach it with the fasteners removed in step 2. Tighten fasteners to 10.9 N·m (8 ft-lbs). | |
5. | Tighten case bolt (3) to 20.4 N·m (15 ft-lbs). |
1 | Case bolt |
2 | Primary fasteners |
1 | Primary cover |
2 | Cylinder base cover |
3 | Case bolt |