FLHR VENTED WINDSHIELD KIT
J056102012-07-03
GENERAL
Kit Number
57400176
Models
For model fitment information, see the P&A Retail Catalog or the Parts and Accessories section of www.harley-davidson.com (English only).
Additional Parts Required
WARNINGRider and passenger safety depend upon the correct installation of this kit.
If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation.
Improper installation of this kit could result in death or serious injury. (00308b)
For proper installation on FLHRS models, separate purchase of Mounting Hardware Kit, Part Number 58221-04.
INSTALLATION
- FLHRS Models: Install hardware mounting kit.
- Lower the windshield into position by carefully inserting the side brackets between the headlamp housing and the passing lamp supports until the bottom notches are seated on the lower grommets.
- Standing at the front of the motorcycle, gently push the top of the windshield toward the rear until the upper notches fully engage the upper grommets.
NOTE
Be sure that the notches on each bracket are firmly seated on a rubber grommet.
CARE AND CLEANING
NOTE
Sunlight reflections off of the inside curvature of a windshield can, at certain times of the day, cause extreme heat build-up on motorcycle instruments. Exercise care in parking. Park facing the sun, place an opaque object over the instruments, or adjust the windshield to avoid reflections.
NOTICE
Use only Harley-Davidson recommended products on Harley-Davidson windshields. Do not use harsh chemicals or rain sheeting products, which can cause windshield surface damage, such as dulling or hazing. (00231c)
Do not clean polycarbonate windshield in hot sun or high temperature. Powdered, abrasive or alkaline cleanser will damage the windshield. Never scrape the windshield with a razor blade or other sharp instruments because permanent damage will result.
NOTE
Covering the windshield with a clean, wet cloth for about 15 minutes before washing will make dried bug removal easier.
Harley-Davidson Windshield Water Repellent Treatment Part Number 99841-01 is approved for use on Harley-Davidson polycarbonate windshields.
SERVICE PARTS
Figure 1. Service Parts: Vented Detachable Windshield
Table 1. Service Parts Table
Item | Description (Quantity) | Part Number |
|---|---|---|
1 | TORX® screws (6) | 10200204 |
2 | Grommet (6) | 11564 |
3 | Windshield mounting bracket (right) | 12700065 |
4 | Windshield mounting bracket (left) | 12700066 |
5 | Air duct vent | 29200027 |
6 | Air duct shroud | 29200028 |
7 | Air duct vane | 29200029 |
8 | Windshield service kit | 57400196 |
9 | Mount | 57400178 |
10 | Windshield mounting screw (6) | 10200218 |
11 | Acorn nut | 7154M |
12 | Tape | 57400175 |