0/0
BURST COLLECTION CLUTCH COVER KIT
J056422012-06-15
GENERAL
Kit Number
34800012
Models
For model fitment information, see the P&A Retail Catalog or the Parts and Accessories section of www.harley-davidson.com (English only).
Additional Parts Required
Separate purchase of gasket (Part No. 36805-06) is required for installation of this kit.
Separate purchase of Loctite® 243 (Blue) (Part No. 99642-97) is required for installation of this kit.
Separate purchase of the appropriate transmission lubricant is required (refer to service manual).
See a Harley-Davidson dealer for additional information.
WARNING
Rider and passenger safety depend upon the correct installation of this kit. Use the appropriate service manual procedures. If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation. Improper installation of this kit could result in death or serious injury. (00333b)
NOTE
This instruction sheet references service manual information. A service manual for your model motorcycle is required for this installation and is available from a Harley-Davidson dealer.
Kit Contents
See Figure 1 and Table 1.
INSTALLATION
WARNING
To prevent accidental vehicle start-up, which could cause death or serious injury, disconnect negative (-) battery cable before proceeding. (00048a)
  1. Disconnect battery cable, negative (-) cable only.
  2. Remove exhaust system only if needed to access hardware. Refer to service manual for instructions.
  3. Drain transmission and dispose of lubricant in accordance with local regulations.
  4. See Figure 1. Remove and discard six original equipment (OE) screws and washers from clutch cover.
  5. Remove clutch cover. Remove and discard gasket. See service manual for instructions.
  6. Install new gasket and clutch cover.
  7. Install six chrome hex socket head screws (1) and washers (2). Refer to service manual for torque sequence and tighten to 84-108 in-lbs (9.5-12.2 Nm).
  8. Fill transmission with appropriate lubricant. See service manual.
  9. If removed, install exhaust system. See service manual.
  10. Connect negative battery cable.
SERVICE PARTS
Figure 1. Service Parts: Burst Collection Clutch Cover
Table 1. Service Parts: Burst Collection Clutch Cover
Item
Description (Quantity)
Part Number
1
Screw, hex socket head, 1/4-20 x 1 inch, chrome (6)
94314-91TS
2
Washer, flat chrome (6)
94062-03
3
Clutch cover
34800013