0/0
RETRACTABLE TOUR-PAK LID TETHER CORD
J056442012-04-03
GENERAL
Kit Number
54171-11
Models
For model fitment information, see the P&A Retail Catalog or the Parts and Accessories section of www.harley-davidson.com (English only).
Kit Contents
See Figure 1 and Figure 2.
There are no Service Parts available with this kit.
INSTALLATION
NOTE
When installing the Retractable Tour-Pak Lid Tether Cord you must support the Tour-Pak lid from falling over and damaging the Tour-Pak lid or tub.
The Tour-Pak will not fit Leather or Sport Tour-Pak luggage.
  1. See Figure 1. Remove the tether screw, washer and cord end from the Tour-Pak lid. Install the washer, tether spool and screw. Tighten screw securely but make sure the tether eyelet pivots freely on the screw.
  2. See Figure 2. While supporting the lid, remove the lower screw and washer from the tub. Discard the wave washer and install the tether eyelet with the screw. Tighten screw securely but make sure the tether eyelet pivots freely on the screw.
    3. NOTE
    Do not overload the Tour-Pak lid rack if equipped or damage can result to the tether and/or Tour-Pak.
1Retractable tether cord
Figure 1. RETRACTABLE TOUR-PAK LID TETHER CORD
1Tether Cord
Figure 2. Tether Cord Attached To Tour-Pak Tub