SUNDOWNER PILLION
J057242012-11-12
GENERAL
Kit Number
52400066
Models
For model fitment information, see the P&A Retail Catalog or the Parts and Accessories section of www.harley-davidson.com (English only).
NOTE
This instruction sheet references service manual information. A service manual for your model motorcycle is required for this installation and is available from a Harley-Davidson Dealer.
Kit Contents
WARNINGRider and passenger safety depend upon the correct installation of this kit.
If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation.
Improper installation of this kit could result in death or serious injury. (00308b)
WARNINGDo not install these seat kits on motorcycles that are not equipped with an appropriate grab strap and passenger footpegs. If footpegs and grab strap are not installed, passenger could fall from moving motorcycle or grab onto operator, causing loss of control and death or serious injury. (00410b)
INSTALLATION
NOTE
When performing the following installation procedures, avoid scratching painted surfaces (fender, tank, etc.) with tools or metal seat tabs.
- See Figure 1. Remove existing pillion from motorcycle by removing screw (E) at rear bracket and unhooking front pillion slots (F).
- Remove seat and grabstrap by removing mushroom screws (D). Discard existing grabstrap and save mounting hardware from the motorcycle.
- Install new grabstrap (2) on studs (C) using the outermost pair of holes on the strap.
- Install solo seat (A) by sliding front tab of the seat into the square frame tube. Secure the rear mount bracket with seat grommets (B) inserted over the studs (C) and secure with the two mushroom nuts (D) and hand tighten.
- Pull grabstrap forward and being careful not to scratch the paint on the fender, slide the pillion mount bracket (F) (at front and bottom of pillion) onto the mushroom head nuts (D).
- Secure the rear of the pillion with stock mounting screw (E) and tighten while pushing down on rear of pillion. Pull up on the front of the pillion to check that the seat is secure.
WARNINGAfter installing seat, pull upward on seat to be sure it is locked in position. While riding, a loose seat can shift causing loss of control, which could result in death or serious injury. (00070b)
SERVICE PARTS
Figure 1. Service Parts: Detachable Pillion Seat
Table 1. Service Parts
Item | Description (Quantity) | Part Number |
|---|---|---|
1 | Pillion assembly | Not Sold Separately |
2 | Grapstrap, 23.5 inch | 51184-00 |
Items mentioned in text, but not included in kit. | ||
A | Solo seat | 52000098 |
B | Seat mount grommet | Not Sold Separately |
C | Seat mount fender stud | Not Sold Separately |
D | Mushroom seat nut | 3633 |
E | Rear pillion tab fastener | 3075 |
F | Front pillion slot mounts | Not Sold Separately |