Battery Replacement Schedule
The siren internal 9 V battery is rechargeable and does not require regular replacement. Battery life under normal conditions is approximately 3-6 years.
NOTE
If the motorcycle battery is less than 12.5 V, the internal siren battery may not charge.
Battery Replacement
  1. Disarm system. Remove siren.
  2. See Figure 1. With a small screwdriver, push the catches (1) in through the two slots (2) in the end of the siren. Release the battery cover (3).
    3. NOTE
    • For protection against corrosion, battery terminals and battery clip are covered with a special grease. Do not wipe away this substance. Apply all available existing grease to terminals on new battery.
    • Use only a 9 V nickel metal hydride battery in the siren.
  3. Replace 9 volt battery (4) by removing old battery from polarized battery clip.
  4. Recharge and install or install a new 9 volt nickel metal hydride battery.
  5. Install cover (3).
    1. Carefully replace the rubber seal (5) on the cover.
    2. Align battery cover with case placing round corners on cover away from connector [142A] (6).
    3. Snap cover into place.
  6. Install siren and check operation. Two chirps after an arming command indicate a working siren.
1Catch (2)
2Slot (2)
3Cover
49V battery
5Rubber seal
6Connector [142A]
Figure 1. Battery Compartment