Always use blocking or proper stands to support the part that has been hoisted. If a part cannot be removed, verify that all bolts and attaching hardware have been removed. Verify that no parts are in the way of the part being removed.

Always tag hoses, wiring or tubes to verify proper installation.

Thoroughly clean all parts to be reused before assembly. Clean parts promote better component operation and longer life. Seals, filters and covers used in this vehicle keep out extraneous dirt and dust. Keep these items in good condition to guarantee satisfactory operation. See Foreword → Foreword → Cleaning.

Check torque using a torque wrench set to the minimum specification for that fastener. If the fastener does not rotate, the torque has been maintained. If the fastener rotates, remove it to determine if it has a threadlocking agent.

If it has a threadlocking agent, clean all material from the threaded hole. See Cleaning Threads and Threaded Holes later in this section. Replace the fastener with a new one or clean the original fastener threads. Use the threadlocker stated in the appropriate procedure. If no threadlocker is indicated, use LOCTITE 243 MEDIUM STRENGTH THREADLOCKER AND SEALANT (BLUE) (99642-97) or equivalent. Install and tighten the fastener to specification.

If the fastener does not use a threadlocking agent, install and tighten it to specification.