Removal
  1. See Controls and Indicators → TOUR-PAK. Open Tour-Pak to move passenger seat backrest out of the way.
  2. Remove screw securing rear of seat.
  3. To protect Tour-Pak finish, cover rear seat mounting bracket with palm of hand.
  4. See Figure 1. While pushing seat forward, raise rear of seat until bracket clears top of Tour-Pak. Push seat rearward slightly to free seat from frame.
Installation
1. See Figure 2. Place seat on frame backbone.
2. To protect finish of Tour-Pak, cover rear seat mounting bracket with palm of hand.
3. While raising rear of seat approximately 76.2 mm (3.0 in), use other hand to firmly push front of seat downward and forward until tongue engages slot in seat.
4. Push seat rearward until rear fender seat retention nut is centered in hole of mounting bracket.
5. Install seat mounting fastener. Tighten to 5.4–8.1 N·m (48–72 in-lbs).
WARNING
After installing seat, pull upward on seat to be sure it is locked in position. While riding, a loose seat can shift causing loss of control, which could result in death or serious injury. (00070b)
6. Pull up on seat to verify that it is properly secured, front and rear.
Figure 1. Seat Tongue
Figure 2. Seat Slot