AUDIO: See Figure 1. Press the AUDIO switch to access the Audio/Setup menu on the LCD. Press and release AUDIO or the press the soft key to toggle to the next displayed function in sequence from Bass, to Treble, to Fade, to Display, to Volume and then to AVC.

If the AUDIO switch is left on any selection the function automatically reverts back to the selected mode after approximately 2-3 seconds.

±: Pressing the AUDIO switch upward (+) raises the level for the currently selected Audio/Setup (Bass, Treble, Fade, Volume or AVC). Pressing the switch downward (-) lowers the level. The level is raised or lowered as long as the switch is held until the minimum or maximum level is reached.

The LCD displays a horizontal dashed line to indicate the level. In the center of the line is a single thin dash. When the level is at the center, the selected audio is at a mid-point of its range.

See C in ADVANCED AUDIO SYSTEM → CB Operation → Display Examples. Fade adjusts the balance between rider and passenger speakers. Pressing AUDIO upward (+) moves the balance to the front speakers while pressing AUDIO downward (-) moves the balance to the rear speakers. Equal volume in front and rear speakers is indicated by one horizontal single line in the center position.

The Display function sets the illumination level of the characters in the LCD display.

The AVC (Automatic Volume Control) function sets the volume level to compensate for the ambient noise associated with motorcycle speed.

See Figure 1. Push-To-Talk (PTT) and the squelch control switch (+/SQ/-) is located on the left handlebar switch assembly.

PTT: With the power ON and the LCD indicating CB is active, press and hold the PTT switch to transmit over the channel displayed. Release PTT to end transmission.

+/SQ/-: Lower the threshold to allow reception of CB signals by pressing the +/SQ/- switch toward the rear (-) or raise the threshold by pressing the +/SQ/- switch toward the front (+).