General
NOTICE
The engine should be allowed to run slowly for 30-60 seconds. This will allow the engine to warm up and let oil reach all surfaces needing lubrication. Failure to comply can result in engine damage. (00181b)
Do not roll the throttle before starting. Rolling the throttle before starting the motorcycle is unnecessary.
Starting
WARNING
Shift transmission to neutral before starting engine to prevent accidental movement, which could result in death or serious injury. (00044a)
  1. Turn ignition switch to IGNITION position. Do not roll the throttle.
  2. See Figure 1. Turn the OFF/RUN switch to RUN position.
  3. NOTE
    The engine lamp will light for approximately 4 seconds and you will hear the fuel pump purr for approximately 2 seconds as it operates to fill the fuel lines with gasoline.
  4. Squeeze the clutch lever in against the handgrip.
  5. NOTE
    To activate the starting system, the clutch interlock circuitry requires the clutch be disengaged, clutch lever pulled in against left handgrip, and/or the transmission be shifted to the neutral position (green neutral lamp lit).
  6. Press the starter button to start the motorcycle.
  7. When the engine has started, you can operate your motorcycle as you normally would after raising the jiffy stand.
NOTE
The ABS indicator lamp will remain on until vehicle is moving approximately 5 km/h (3 mph).
1Engine off/run switch
2Engine start switch
Figure 1. Right Handlebar Controls: V-Rod Models