See Figure 1. The engine check lamp is located near the lower left side of the speedometer face. Its purpose is to indicate whether or not the engine/engine management system is operating normally. The engine lamp color is amber.

The engine lamp normally comes on when the ignition is first turned on and remains on for approximately 4 seconds, as the engine management system runs a series of self-diagnostics.

If the engine lamp comes on at any other time, see a Harley-Davidson dealer.

See Figure 1. The low fuel lamp is located in the speedometer face, lower center by check engine lamp. The low fuel lamp indicates low fuel level in the tank. Refer to Specifications → Specifications → Capacities. Refill the tank as soon as possible. The low fuel lamp color is amber.

If the low fuel lamp remains lit after adding fuel or filling the fuel tank, see your Harley-Davidson dealer.

See Figure 1. The red battery charging lamp indicates either overcharging or undercharging of the battery. Refer to Maintenance and Lubrication → Battery: General.

See Figure 1. A green lamp on the tachometer face indicates the cruise control is SET or NOT SET. An orange lamp on the cruise control switch indicates the cruise control is ON or OFF. Refer to Controls and Indicators → Cruise Control Operation.

See Figure 1. The amber sixth gear lamp on the speedometer face indicates when the transmission is in sixth gear.

See Figure 1. The red security system lamp on the speedometer face indicates when the security system is armed. Refer to Hands-Free Security Module → HARLEY-DAVIDSON SMART SECURITY SYSTEM.

If the security system lamp remains lit after the security system is disarmed, see your Harley-Davidson dealer.

The reverse enable lamp is located with the reverse controls on the left handlebar (if equipped). This yellow lamp is lit when reverse operation is enabled. See Controls and Indicators → Reverse Operation.