General
NOTICE
The engine should be allowed to run slowly for 15-30 seconds. This will allow the engine to warm up and let oil reach all surfaces needing lubrication. Failure to comply can result in engine damage. (00563b)
Do not roll the throttle before starting. Rolling the throttle before starting the motorcycle is unnecessary.
Starting
| 1. | Verify that transmission is in gear. | |
| 2. | Turn ignition/headlamp key switch to IGNITION position. Do not roll the throttle. | |
 WARNINGShift transmission to neutral before starting engine to prevent accidental movement, which could result in death or serious injury. (00044a) | ||
| 3. | Shift transmission to neutral. | |
| 4. | See Figure 1. Turn the off/run switch to RUN position. NOTE The engine lamp will light for approximately 4 seconds and you will hear the fuel pump operating for approximately 2 seconds as it fills the fuel lines with gasoline. | |
| 5. | Squeeze the clutch lever in against the handgrip. NOTE To activate the starting system, the clutch interlock circuitry requires the clutch be disengaged, clutch lever pulled in against left handgrip, and/or the transmission be shifted to the neutral position (green neutral lamp lit). | |
| 6. | Press the starter button to start the motorcycle. | |
| 7. | Release the parking brake before riding the motorcycle. See Controls and Indicators → Reverse Operation. |
NOTE
If the fuel tank becomes completely dry, it may take a few seconds longer to start the motorcycle after filling the tank. It will not be necessary to take any extraordinary measures before starting the motorcycle.
| 1 | Engine off/run switch |
| 2 | Engine start switch |
Figure 1. Right Handlebar Controls