1. | Slide rear of seat through grab strap. | |
2. | See Figure 2. Firmly push front of seat downward and then forward until slot engages tongue. | |
WARNING After installing seat, pull upward on seat to be sure it is locked in position. While riding, a loose seat can shift causing loss of control, which could result in death or serious injury. (00070b) | ||
3. | Secure rear of seat with screw and tighten to 5.4–8.1 N·m (48–72 in-lbs). |
1. | See Figure 2. Place seat on frame backbone. | |
2. | To protect finish of Tour-Pak, cover rear seat mounting bracket with palm of hand. | |
3. | While raising rear of seat approximately 76.2 mm (3.0 in), use other hand to firmly push front of seat downward and rearward until tongue engages slot in seat. | |
4. | Push seat forward until rear seat retention nut is aligned with hole of mounting bracket. | |
5. | Install seat mounting fastener. Tighten to 2.3–4.5 N·m (20–40 in-lbs). | |
WARNING After installing seat, pull upward on seat to be sure it is locked in position. While riding, a loose seat can shift causing loss of control, which could result in death or serious injury. (00070b) | ||
6. | Pull up on seat to verify that it is properly secured, front and rear. |