General
NOTICE
The engine should be allowed to run slowly for 15-30 seconds. This will allow the engine to warm up and let oil reach all surfaces needing lubrication. Failure to comply can result in engine damage. (00563b)
  1. With security system fob present, turn ignition switch to IGNITION.
  2. Set the OFF/RUN switch to the RUN. See Figure 1.
    3. NOTE
    The check engine lamp briefly lights as the fuel pump operates to fill the fuel lines.
Starting Engine In Neutral
  1. Apply the front or rear brake to prevent movement of the motorcycle.
  2. Squeeze the clutch lever in against the hand grip. Shift transmission to neutral (with the green neutral lamp lit).
  3. Do not roll the throttle.
  4. Press the engine start switch to start the engine.
Starting Engine In Gear
  1. You must apply the front or rear brake to start the engine and to prevent movement of the motorcycle.
  2. You must squeeze the clutch lever in against the hand grip.
  3. Do not roll the throttle.
  4. Press the engine start switch to start the engine.
NOTE
If the engine does not start, the starter motor will operate for five seconds and then stop. Release and press the START switch. After several unsuccessful start attempts, see Troubleshooting → Engine. See an authorized Harley-Davidson dealer for service.
When the engine has started, release the parking brake before riding the motorcycle as you normally would. See Controls and Indicators → Parking Brake.
1Engine off/run switch
2Engine start switch
Figure 1. Right Handlebar Controls