CAUTION

Prolonged or repeated contact with used motor oil may be harmful to skin and could cause skin cancer. Promptly wash affected areas with soap and water. (00358b)

NOTICE

Oil level cannot be accurately measured on a cold engine. For pre-ride inspection, with motorcycle on level ground, oil should register on dipstick between arrows when engine is cold. Do not add oil to bring the level to the FULL mark on a COLD engine. (00589b)

NOTE

See Figure 2. When checking oil level, use the gauge marked FULL HOT VEHICLE UPRIGHT.

Oil Level Cold Check

Perform engine oil level COLD CHECK as follows:

For pre-ride inspection, park vehicle on level ground.
See Figure 1. Remove filler plug/dipstick and wipe off the dipstick. Insert the dipstick and tighten into the fill spout.

NOTE

Oil level on a cold engine should never be above the midway point.

See Figure 2. Remove filler plug/dipstick. Using the gauge marked FULL HOT VEHICLE UPRIGHT on the dipstick, verify the oil level. The correct oil level should register midway (2) between the ADD QT and FULL HOT marks on the dipstick.

NOTE

If oil level is at or below the ADD QT mark, add only enough oil to bring the level midway (2) between the ADD QT and FULL HOT marks. Never bring the level to the FULL HOT mark on a cold engine.

Oil Level Hot Check

NOTE

The engine will require a longer warm up period in colder weather.
Perform engine oil level hot check only when engine is at normal operating temperature.

Perform engine oil level HOT CHECK as follows:

Ride motorcycle until engine is at normal operating temperature.
Park vehicle on level ground. Allow engine to idle for 1-2 minutes. Turn engine off.
Remove filler plug/dipstick and wipe off the dipstick. Insert the dipstick and tighten into the fill spout.
See Figure 2. Remove filler plug/dipstick. Using the gauge marked FULL HOT VEHICLE UPRIGHT on the dipstick, verify the oil level. The level should be between the ADD QT (1) and FULL HOT (3) marks. Add oil as necessary to bring the level to the FULL HOT mark on the dipstick. Do not overfill.

NOTE

Refer to Maintenance and Lubrication → Engine Lubrication → Recommended Engine Oils. Use only recommended oil specified in Maintenance and Lubrication → Engine Lubrication.

Start engine and carefully check for oil leaks around drain plug and oil filter.

NOTICE

Do not allow hot oil level to fall below Add/Fill mark on dipstick. Doing so can result in equipment damage and/or equipment malfunction. (00189a)

NOTICE

Do not overfill oil. Doing so can result in oil carryover to the air cleaner leading to equipment damage and/or equipment malfunction. (00190b)

Check engine oil level at each complete fuel refill.
Refer to Maintenance Scheduling → Regular Service Intervals → Regular Service Intervals: 2015 Trike Models. Oil should be changed at specified intervals in normal service at warm or moderate temperatures.
Oil change intervals should be more frequent in cold weather or severe operating conditions. See Maintenance and Lubrication → Winter Lubrication.

Figure 1. Engine Oil Filler Cap

1	ADD QT (lower) mark
2	Cold check level
3	FULL HOT (hot check) mark

Figure 2. Engine Oil Dipstick (VEHICLE UPRIGHT Gauge)