General

The transmission lubricant level should be checked monthly.

Refer to Maintenance Scheduling → Regular Service Intervals → Regular Service Intervals: 2007 Touring Models. The transmission should be drained and refilled with fresh lubricant at specified intervals.

NOTE

When checking the transmission lubricant level, motorcycle should be leaning on the jiffy stand. Allow a short period of time to equalize lubricant level in the transmission compartments.

Check Lubricant Level

1.	Park motorcycle on its jiffy stand.
2.	See Figure 1. Remove the threaded filler plug/dipstick.
3.	Wipe off filler plug/dipstick. Place in filler hole and remove. (Dipstick should rest on lip of filler.) Do not screw in. Lubricant level should be between the full and low marks on the plug/dipstick when removed. NOTE Lubricant level should be between the two marks on the dipstick.
	WARNING Be sure that no lubricants or fluids get on tires, wheels or brakes when changing fluid. Traction can be adversely affected, which could result in loss of control of the motorcycle and death or serious injury. (00047d) NOTICE When draining or adding lubricant, do not allow dirt, debris or other contaminants to enter the engine. (00198a)
4.	Add lubricant, if necessary. Do not overfill or leakage may occur. When filling the transmission, use GENUINE Harley-Davidson FORMULA+ TRANSMISSION AND PRIMARY CHAINCASE LUBRICANT (Part No. 99851-05 quart). The transmission fluid capacity is approximately 32 ounces (0.95 liters).
5.	Inspect o-ring for tears or damage. Replace if required. Wipe any foreign material from plug.
6.	Install threaded filler/check plug and tighten clockwise to 2.8–8.5 N·m (25–75 in-lbs).

1	FULL
2	ADD

Figure 1. Transmission Filler Plug/Dipstick Lubricant Level

Figure 2. Transmission Filler Plug/Dipstick Location

Changing Transmission Fluid

1.	See Figure 2. Remove the threaded check/filler plug.
2.	See Maintenance and Lubrication → Changing Oil and Oil Filter: Touring Models → Oil Pan: Touring Models. Remove transmission drain plug from the right side of the oil pan and drain lubricant into a suitable container. NOTE Dispose of transmission lubricant in accordance with local regulations.
	NOTICE When draining or adding lubricant, do not allow dirt, debris or other contaminants to enter the engine. (00198a) WARNING Be sure that no lubricants or fluids get on tires, wheels or brakes when changing fluid. Traction can be adversely affected, which could result in loss of control of the motorcycle and death or serious injury. (00047d)
3.	Inspect o-ring for tears or damage on the drain plug. Replace if required. Wipe any foreign material from plug.
4.	Install drain plug and tighten to 19–28.5 N·m (14–21 ft-lbs). Fill the transmission with 32 oz. (0.95 liters) of GENUINE Harley-Davidson FORMULA+ TRANSMISSION AND PRIMARY CHAINCASE LUBRICANT (Part No. 99851-05 quart). NOTE Do not overfill or leakage may occur. The transmission fluid capacity is approximately 32 ounces (0.95 liters).
5.	Install threaded filler/check plug and tighten clockwise to 2.8–8.5 N·m (25–75 in-lbs).
6.	Start engine and carefully check for oil leaks around drain plug.