General
NOTICE
The engine should be allowed to run slowly for 15-30 seconds. This will allow the engine to warm up and let oil reach all surfaces needing lubrication. Failure to comply can result in engine damage. (00563b)
Do not roll the throttle before starting. Rolling the throttle before starting the motorcycle is unnecessary.
Starting
WARNING
Shift transmission to neutral before starting engine to prevent accidental movement, which could result in death or serious injury. (00044a)
  1. Turn ignition/headlamp key switch to IGNITION position. Do not roll the throttle.
  2. See Controls and Indicators → Hand Controls: Basic Operation → Handlebar Controls. Rock the OFF/RUN switch to the RUN position.
    3. NOTE
    The engine lamp will light for approximately 4 seconds and you will hear the fuel pump purr for approximately 2 seconds as it operates to fill the fuel lines with gasoline.
  3. Verify transmission is in NEUTRAL position by observing the lit green neutral indicator lamp on the dash panel and verify neutral position by rolling motorcycle forward and rearward.
  4. Squeeze the clutch lever against the handlebar.
  5. Press the starter button to start the motorcycle.
  6. When the engine has started, you can operate your motorcycle as you normally would after raising the jiffy stand.
1Engine off/run switch
2Engine start switch
Figure 1. Right Handlebar Controls