1. | Install new bulb and assemble the headlamp components. | |
2. | For International Models Only: Install new bulb in boot. Install boot in housing and rotate one-quarter turn. | |
3. | Verify slots and tabs in headlamp and trim ring are aligned. | |
4. | Install rubber boot with word TOP at the top of the headlamp lens assembly. | |
5. | Connect the headlamp connector. | |
6. | Install trim ring and screw. | |
7. | Install main fuse. | |
WARNING Be sure that all lights and switches operate properly before operating motorcycle. Low visibility of rider can result in death or serious injury. (00316a) | ||
8. | Turn ignition on and test for proper operation. | |
9. | If necessary, align headlamp assembly. See Maintenance and Lubrication → Headlamp Alignment. |
1 | Screw |
2 | Trim ring |
3 | Headlamp lens |
4 | Gasket |
5 | Bulb |
6 | Wire retaining clip |
7 | Bulb, position (international models) |
8 | Boot |
9 | Mounting ring |
10 | Shell assembly |
1 | Wire retaining clip |
2 | Retainer |