Removal
  1. See Figure 3. Disconnect the audio system power connector on the left side of the steering head.
  2. See Figure 1. Place one hand on the top of the windshield and the other hand on the bottom of the fairing. Pull the windshield toward the front of the motorcycle to disengage the upper bracket, then lift the fairing to unseat the bracket from the lower grommets.
  3. Carefully pull the audio system power cable through the gap between the headlamp and front panel. Install the cap on the motorcycle wire harness.
Installation
  1. See Figure 2. Feed the audio system power cable between the headlamp and front panel.
  2. Stand in front of the vehicle and align the fairing with the headlamp.
  3. Slide the fairing bracket notches onto the top and bottom grommets, firmly pressing down and toward the motorcycle until the fairing bracket is firmly seated.
  4. See Figure 3. Connect the audio system power connector. Make sure audio connection harness does not pinch, bind or interfere when handlebars are turned fully to left or right fork stops.
WARNING
Be sure that steering is smooth and free without interference. Interference with steering could result in loss of vehicle control and death or serious injury. (00371a)
NOTE
For proper windshield maintenance, see .
Figure 1. Removing Compact Fairing
1Upper bracket/grommet
2Lower bracket/grommet (behind turn signal lamp)
3Audio system power cable
Figure 2. Compact Fairing
Figure 3. Audio System Power Connector