Removal
NOTE
The seat screw may be difficult to access if the Tour-Pak is in the forward position. If necessary, see Controls and Indicators → TOUR-PAK to temporarily reposition the Tour-Pak.
| 1. | Open Tour-Pak lid. | |
| 2. | Open one of the saddlebag lids. | |
| 3. | See Figure 1. Remove screw to release seat strap from bracket. | |
NOTICE Detach passenger seat strap before removing seat. Failure to do so can result in damage to rear fender paint. (00225a) | ||
| 4. | FLHRC: See Figure 4. Pull strap through slots in seat to remove. | |
| 5. | Remove screw to release seat from top of rear fender. NOTE Cover the seat mount mounting bracket with palm of hand to prevent damage to Tour-Pak. | |
| 6. | See Figure 2 and Figure 3. Raise rear of seat. Pull seat rearward to disengage the tongue from the slot in the seat. |
Installation
NOTE
Cover the seat mount mounting bracket with palm of hand to prevent damage to Tour-Pak.
| 1. | See Figure 2 and Figure 3. Align seat slot with tongue behind the fuel tank. Push seat forward to engage seat. | |
| 2. | See Figure 1. Secure seat bracket to rear fender with screw. Tighten screw to 5.4–8.1 N·m (48–72 in-lbs). | |
 WARNINGAfter installing seat, pull upward on seat to be sure it is locked in position. While riding, a loose seat can shift causing loss of control, which could result in death or serious injury. (00070b) | ||
| 3. | Pull up on seat to check that it is properly secured. | |
| 4. | FLHRC: See Figure 4. Install strap through slots in seat. | |
| 5. | See Figure 1. Insert strap in slot on seat strap bracket. | |
| 6. | Install screw and washer. Tighten to 5.4–8.1 N·m (48–72 in-lbs). | |
| 7. | Close the saddlebag lid. | |
| 8. | Close Tour-Pak lid. |
NOTE
Install Tour-Pak back in desired position if removed. See Controls and Indicators → TOUR-PAK.
| 1 | Seat strap screw |
| 2 | Seat strap |
| 3 | Seat screw |
Figure 1. Seat (typical)
Figure 2. Seat Tongue
Figure 3. Seat Mounting Slot
Figure 4. Strap Slots: FLHRC